Homemade Bolt Cutter Rivet Crusher
PLANS:
None. For all tools with plans, click here.
BUILDER:
CatCow on garagejournal.com
DESCRIPTION:
Homemade Harbor Freight bolt cutter ground down to function as a rivet crusher. Made specifically for the rivets on an AK-47 receiver.
RATING:
(3)
Feb 03, 2018 1:28 PM
straightshooter
did anyone get back on this feed on how to make one of these bolt rivet cutters?
May 21, 2016 10:03 PM
TomZ124cc
I would like to make one of these for my 74 build. I was wondering if you could provide some dimensions to cut this "Chinook Salmon Jaw" ?It appears that you have removed about a 1/4" from the cutting edge of the jaws and then squared up the hook portion, about 3/8" X 1/2" long and beveled slightly. How much was removed from the top to allow it to get inside the Trunnion?
Rate this build:
CATEGORIES:
TAGS:
Newest Forum Posts
- Audio and data connector identification guide - photo by Philip Davies on 2024-11-24 12:25:47
- Harvesting and eating tamilok - GIF by BuffaloJohn on 2024-11-24 11:28:07
- Cheryl Ladd in Charlie's Angels in 1974 - GIF by Jon on 2024-11-24 11:23:39
- Workers try to extinguish lithium ion battery fire with water - GIF by Frank S on 2024-11-24 10:59:59
- Cleaning out a clogged restaurant grease trap - GIF by ToolTalkBot on 2024-11-24 10:27:01
- Adjustable Clamp!! by orioncons36 on 2024-11-24 09:25:53
- 1752 Philadelphia tilting sink - GIF by Floradawg on 2024-11-24 09:15:50
- How boats get past hydraulic dams - GIF by nova_robotics on 2024-11-24 09:05:35
- Launching anvils to the sky - GIF by marksbug on 2024-11-24 08:57:36
- House falls after being hit by waves - GIF by Karl_H on 2024-11-24 08:49:47
DIY Bolt Cutter Rivet Crusher - comment on how to build a Bolt Cutter Rivet Crusher - 3 comments
straightshooter says:
Feb 03, 2018 1:28 PM
did anyone get back on this feed on how to make one of these bolt rivet cutters?
TomZ124cc says:
May 21, 2016 10:03 PM
I would like to make one of these for my 74 build. I was wondering if you could provide some dimensions to cut this "Chinook Salmon Jaw" ?It appears that you have removed about a 1/4" from the cutting edge of the jaws and then squared up the hook portion, about 3/8" X 1/2" long and beveled slightly. How much was removed from the top to allow it to get inside the Trunnion?
Related Homemade Tools:
Signup for our newsletter and get the 186 More Best Homemade Tools eBook free!
- BuildThreads Network:
- HomeMadeTools.net
- BikeBuilds.net
- FordBuilds.net
- ChevyBuilds.net
- 4x4Builds.net
- BoatBuilds.net
- PlaneBuilds.net
- CabinBuilds.net
- GarageBuilds.net
- MuscleCarBuilds.net
- HotRodBuilds.net
- GMBuilds.net
- TruckBuilds.net