Here are the plans by Doug Ross:
http://www.homemadetools.net/forum/u...9360#post89149
I wanted to make one a bit smaller so I used 2.5" diameter steel for the rotors.
Most of the other parts were made to fit this diameter.
Hot rolled steel was on hand so I used that for the rotors and cold rolled for the flat parts.
Very nice set of complete plans from Doug.
I did not put any numbers on the graduations yet and may do that after I make a stamping fixture.
The divisions are a little cramped with only a 2.5" diameter but are very readable. I think this is just
the ticket for sharpening and forming lathe tool bits.
Cheers, JR
Bookmarks