Slender bick for forging

[Philip Davies]

While finishing the cone mandrel, just posted, I was working on this, as well as other things.


Perhaps you can say what the spike is? I think it is a marlinspike.


Something else salvaged! Too good to waste.

This is why I want a bick and a cone mandrel.


See, it gets in nicely round the spiral arms. This spiral was started while the bolt was heating, and continued afterwards.

I found a couple of scrap flat pieces, one of which had a hole which was a loose fit on the spike, welded them together after drilling a hole in the other bit for the tapered pin, which locks the assembly.



A brass ferrule from an old tool handle over the spike makes a tight fit.

[DIYer]

Thanks Philip Davies! We've added your Slender Bick to our Forging and Casting category,
as well as to your builder page: Philip Davies's Homemade Tools. Your receipt:

Slender Bick by Philip Davies

tags: forging