13/16" line wrench form box end

**Frank S** · Apr 13, 2022, 10:27 PM

I have a set of line wrenches but they are all too thick to fit in some places. My set of crows feet wrenches will not always get into the tight spaces I sometimes encounter. Hense a sacrificial box end wrench to the rescue

13/16" line wrench form box end-img_20220413_164003lw.jpg

13/16" line wrench form box end-img_20220413_164057lw.jpg

**DIYer** · Apr 14, 2022, 05:46 AM

Thanks Frank S! We've added your Line Wrench to our Fastening category,
as well as to your builder page: Frank S's Homemade Tools. Your receipt:

Line Wrench by Frank S

tags: wrench, hand tools

**NortonDommi** · Apr 20, 2022, 04:19 PM

Got a few of those floating around the toolbox. The greatly offset ones are essential on some jobs but damn hard chopping up an expensive spanner and you need some decent quality or they just spring apart and bugger up the hex on the thing you are trying to get out.
Extra long deep reach hex sockets with slots cut out of the sides are handy too.

**Frank S** · Nov 12, 2024, 11:58 AM

Originally Posted by NortonDommi

Got a few of those floating around the toolbox. The greatly offset ones are essential on some jobs but damn hard chopping up an expensive spanner and you need some decent quality or they just spring apart and bugger up the hex on the thing you are trying to get out.
Extra long deep reach hex sockets with slots cut out of the sides are handy too.

I don't have a problem with heating and bending snap-on wrenches, to me the only thing snap on wrenches are good for is to make tools that don't exist out of, since they are too thin and slick to get a good grip. But never cut the box end of a snap-on open unless you absolutely need a very slim spanner to get into a tight spot and hope whatever you have to loosen is not over tightened because a cut open snap-on may as well have been chineseum the way they spring open.

**IntheGroove** · Nov 12, 2024, 12:54 PM

I agree on not cutting Snap On open end wrenches. I cut this one over thirty years ago, used it once and it barely did whatever I needed it to do and it flexed quite a bit..

13/16" line wrench form box end-img_3829.jpg

**Philip Davies** · Today, 07:15 AM

You have reminded me of tools I made for woodturning. I do not know whether your box-end spanners can be hardenened and tempered? In the UK, they’re called ring spanners, and box spanners are tubes. I have used the tubes for all sorts of things, because their diameters often differ from usual stock sizes.