Brian,
Looks like you had much better luck with the parting tool than did Halligan142 on his YouTube channel.
These are expensive, but I use ISCAR SGFH 19-2 and 26-3 self-grip blades for parting and grooving with single-ended inserts that work extremely well. I especially like the ISCAR GFR 3W-4D chipformer inserts with a central ridge that forms double cavities on the rake face. The metal chips never seem to jam inside the cutting slot because of the way the central ridge curls the chips.
Thanks for the video,
Paul
thanks Paul, that part has been in my lathe for a week now and I was debating on how to part it off when I saw Halligan142's video and so I just went with it, set up just one camera and not very good angle and heck it worked nicely. I'm going to have a look at the insert tools you listed. thanks again
Paul Jones (Jul 14, 2016)
Thanks bstanga! We've added your Parting Off Method for Titanium to our Machining category,
as well as to your builder page: bstanga's Homemade Tools. Your receipt:
New plans added on 11/20: Click here for 2,589 plans for homemade tools.
Hi Brian,
For this one, you seem to have a fairly deep hole in the center, you managed to do it with your drilling method?
Cheers,
christophe
Cheers !
Christophe
________________________________________________________________
Visit my Website : http://www.labellenote.fr/
Facebook : La Belle Note
All my personal works, unless explicitly specified, are released under
Creative Commons BY-NC-SA license.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks