SteelCraft (Jul 29, 2023)
Never try to tell me it can't be done
When I have to paint I use KBS products
SteelCraft (Jul 29, 2023)
SteelCraft (Jul 29, 2023)
I have had good success using sand that was almost powder and oil and 80/20 to 90/10 sand to oil for vibration dampening. in a 10 HP gantry drill it also seemed to add a lot of stiffness we drilled a 2" hole near the top of the columns then filled the columns and the gantry cross beam a few inches with sand added a bit of oil then rinsed and repeat until the columns were full. Made a huge difference in the performance of the machine and lowered the overall sound level significantly, virtually eliminated and chatter when drilling with 2" and larger drill bits.
Never try to tell me it can't be done
When I have to paint I use KBS products
mwmkravchenko (Jul 29, 2023), Scotty1 (Jul 29, 2023), SteelCraft (Jul 30, 2023)
mwmkravchenko (Aug 10, 2023)
johncg (Oct 2, 2023), mwmkravchenko (Sep 18, 2023)
Hello
Some newest photos. Ton of hand scraping done in those photos and still one of the guides (right one) is 0,2 mm wider on last 15 cm on the bottom. I found this defect after putting everything together, rest 70cm works perfectly. So more hand scraping is waiting...
Oh and I screw up a backplate of the knee. It turned out that Y axis would not be square to Z axis of the machine. It was like 2mm of difference on distance of 530 mm. I tried to grind the backplate but I made it worse. I mean It was square vertically but got twisted. I had to cut off this piece and make, a new one (you can see it on photos above).
mwmkravchenko (Oct 1, 2023), nova_robotics (Oct 2, 2023)
SteelCraft (Oct 2, 2023)
mwmkravchenko (Oct 2, 2023)
mwmkravchenko (Oct 14, 2023)
There are currently 7 users browsing this thread. (0 members and 7 guests)
Bookmarks