New plans added on 01/01/2025: Click here for 2,661 plans for homemade tools.
Andyt (Jun 30, 2020), baja (Jun 30, 2020), clydeman (Jun 29, 2020), KustomsbyKent (Jun 30, 2020), mwmkravchenko (Jul 1, 2020), Rangi (Jul 4, 2020)
Same basic concept as the automatic auto-tie balers we use for our scrap paper... without the auto-tie and automatic parts (Balemaster type). The "rails" on the top and bottom narrow to final dimension so as you press the new in, it compresses tighter and tighter as it pushes through. The panel they insert allows them to push the wire through to tie it off for the one at the end and start the new. . New wires are pushed through for the next bale and these wires push through the slots in the sides as the material is pushed through. After it's tied off the next bale pushes the tied bale out the end and it expands a little into the tied wires making a nice compact bale.
mr maunal does a pretty good job at this.
Better than a old fashioned hay pile. Hats off to the ingenuity!
That's not my dad operating the baler for sure because those bales don't even weigh 100#.
If you can't make it precise make it adjustable.
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks