Making a Stuart 10V Steam Engine

[PaulsGarageProjects]

Hi all,

Here's the first in a series of videos about making a Stuart 10V model steam engine.

Cheers,
Paul.

[PaulsGarageProjects]

Here's the second part. In this one I make the cylinder, caps, valve chest and valve rod.

[PaulsGarageProjects]

Here's the third part. In this one I make the crankshaft, crankshaft bearings and flywheel.

[PaulsGarageProjects]

Hi all,

Here's the fourth part in the series. In this one I make the conrod, crosshead, piston and piston rod.

Cheers,
Paul.

[PaulsGarageProjects]

Hi all,

Here's the fifth and final part in the series. In this one I make the piston rod gland, eccentric rod gland, eccentric sheave and conrod. I also install the gaskets and give it its first test run.

Cheers,
Paul.