Long part mill outrigger. By Joe Pieczynski. 2:48 video:
Tonyg (Jun 11, 2020), Toolmaker51 (Jun 10, 2020)
Concept is great. Beats tying down an angle plate any day.
However & perhaps; length/ contact of perpendicular mating surfaces of bar in jaws, and attached to back of hard jaw, should be repeated to that holding the "Z" axis, not 90° to them. When you swivel the ram, tram is lost. This would require additional effort to get square part features.
And don't use these on whichever side your oiler is located.
Sincerely,
Toolmaker51
...we'll learn more by wandering than searching...
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks