Homemade Lathe keyway cutting attachment

[bouboulas]

Hello everybody
This is my new construction Homemade Lathe keyway cutting attachment
I wish you like it !

[DIYer]

Thanks bouboulas! We've added your Keyway Cutting Attachment to our Lathe Accessories category,
as well as to your builder page: bouboulas's Homemade Tools. Your receipt:

Keyway Cutting Attachment by bouboulas

tags: lathe, keyway, cutting

[Lee Bell]

Nice movie but if you are not going to narrate what your doing, then please just leave it silent. That canned beatbox music is very distracting from the movie of what your doing.

[bouboulas]

Nice movie but if you are not going to narrate what your doing, then please just leave it silent. That canned beatbox music is very distracting from the movie of what your doing.

I think the video without music its very boring

[mklotz]

I think the video without music its very boring

Music perhaps, but not that tribal thumping.

[Karl_H]

My computers all have a volume control!

Thanks for the build video. I got a bit confused because the piston and handle look so alike. You finished the piston beautifully, then I thought you were starting over with the rusty bar. I had to go back and check before I realized that the rusty piece was used for the handle. (It sure cleaned up nicely.)

Thanks again.

[MeJasonT]

Like the use of the ironing board, how did you get it out the house and back in without your partner going ballistic.
Music is good, forget the old people they just love to complain lol.

[bouboulas]

Like the use of the ironing board, how did you get it out the house and back in without your partner going ballistic.
Music is good, forget the old people they just love to complain lol.

She didn’t see me when I stole it