This has been quite a simple, but rewarding build. The free hand turning tool has been designed for the Warco WM240B, but the idea could be adapted for most lathes. This would even work on a wood lathe for turning precise wooden balls or curves.
Also, here is a close up of the free hand turning tool
bruce.desertrat (Dec 11, 2021), Bullet500 (Dec 13, 2021), Dimsa (Dec 6, 2021), DIYSwede (Dec 5, 2021), emu roo (Dec 7, 2021), Home-PC (Dec 7, 2021), Inner (Dec 10, 2021), johncg (Dec 7, 2021), Jon (Dec 6, 2021), lassab999 (Dec 7, 2021), mwmkravchenko (Dec 8, 2021), nova_robotics (Dec 6, 2021), Ralphxyz (Dec 8, 2021), SculptyWorks (Dec 10, 2021), that_other_guy (Dec 10, 2021), Toolmaker51 (Dec 11, 2021)
Nicely designed and cleverly executed, Nigel!
You could also add a profile / tracer attachment as these guys offer for just under 400 bucks:
https://www.eccentricengineering.com...turning-system
All the best!
Cheers
Johan
editor@glue-it.com (Dec 6, 2021), Home-PC (Dec 7, 2021)
Thanks editor@glue-it.com! We've added your Freehand Ball Turning Tool to our Machining category,
as well as to your builder page: editor@glue-it.com's Homemade Tools. Your receipt:
New plans added on 11/22: Click here for 2,593 plans for homemade tools.
that's cool, would be great from creating brass parts like the chimney cap on the traction engine, thanksOriginally Posted by DIYSwede
Nicely designed and cleverly executed, Nigel!
You could also add a profile / tracer attachment as these guys offer for just under 400 bucks:
https://www.eccentricengineering.com...turning-system
All the best!
Cheers
Johan
good one !
editor@glue-it.com (Dec 7, 2021)
Good idea, what bit are you using to engrave slots in brass?
Not so much a BALL TURNER as an end-radiusing tool. I wouldn't like to be holding the tool if I made a mistake and the cutting tool dug into the brass!This has been quite a simple, but rewarding build. The free hand turning tool has been designed for the Warco WM240B, but the idea could be adapted for most lathes. This would even work on a wood lathe for turning precise wooden balls or curves.
Also, here is a close up of the free hand turning tool
Hi Bob, hopefully this video and a quick page on the engraving bits will help:
Many thanks
Maybe I'm being a bit over cautious in my thoughts but since this holder is not mounted down, I can't help but wonder if the base diameter to the height of the cutter ratio is sufficient to prevent vibration or the cutter gouging in too deep, I'll admit to having never ran a lathe with a smaller swing than 10" and most of my work involves a lot heavier turning.
Never try to tell me it can't be done
When I have to paint I use KBS products
There are currently 1 users browsing this thread. (0 members and 1 guests)
Posting Permissions
LinkBack URL
About LinkBacks
Reply With Quote
Bookmarks