Concrete mixer. By AvE. 16:11 video:
Previously:
Electric concrete mixer - video
Concrete fence post removal tool - video
Concrete mixer. By AvE. 16:11 video:
Previously:
Electric concrete mixer - video
Concrete fence post removal tool - video
New plans added on 11/22: Click here for 2,593 plans for homemade tools.
jimfols (Jun 4, 2021), nova_robotics (Jun 4, 2021)
NortonDommi (Jun 4, 2021), nova_robotics (Jun 5, 2021)
NortonDommi (Jun 4, 2021)
Did AvE have a stroke or something? That's a pretty sub-par effort for him. Are we being trolled? Is that why he's using a zip cut like that with no guard? Was that why he was going on about apprentices at the beginning?
And why did he dump all that dirty old hydraulic oil INTO THE PLACE WHERE HE'S GOING TO BE MIXING CONCRETE?
Ooof. And WAY too much water. 35 MPa that is not.
Last edited by nova_robotics; Jun 5, 2021 at 12:34 AM.
Right from the beginning you could see where this was going with that small diameter flighting, but I think he knew that.
Does anyone seriously believe that he didn't clean the hydraulic oil out of the bucket before adding the sand and gravel. even though he did not show it being done on the video?
At the very end he mentioned about adding a counter rotating motor to the opposite end and larger diameter flighting, so he knew his rig was under powered and under flighted.
As far as too much water goes, YEPERS but with the undersized auger there was no way he was going to get a consistent mix with that rig even if he had filled the bucket with water. He would have been better off ripping out the auger and completing the mix with a shovel adding sand gravel and Portland until the water content was closer to being a good mix.
Not everyone has guts enough to post a failed tool though but utubers are a different breed most of their videos are posted for the clicks anyway
Never try to tell me it can't be done
When I have to paint I use KBS products
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks