New tool for milling repeatable chamfers.

**Mook** · Apr 28, 2024, 01:07 PM

I always found it a bit of a pain to hold a part on a 45 degree plate and tighten a milling vise to machine a chamfer. If I pushed down it would slide along the bottom of the vise and the depth in the vise was not easily controlled. Vee blocks work, but the bottom of the vee is often near the top of the jaws not leaving much to clamp on.

Following the precision milling vise square theme, I have made a similar product but at 45 degrees instead of square. The tool incorporates several holes to use to set the height of the part and a stop to prevent the tool sliding. As before, the datum is the top of the vise jaw and not the base making it easier to wipe clean instead of fishing about between the jaws.

**DIYer** · May 2, 2024, 03:14 AM

Thanks Mook! We've added your Adjustable Chamfer Stop to our Machining category,
as well as to your builder page: Mook's Homemade Tools. Your receipt:

Adjustable Chamfer Stop by Mook

tags: chamfer

**Jon** · May 3, 2024, 03:12 PM

Congratulations Mook - your Adjustable Chamfer Stop is the Homemade Tool of the Week!

Beautiful job on a unique und useful workholding tool.

Some more good builds from this week:

Chamber Headspace Gauge by hemmjo
Welding Clamp by orioncons36
Tapping Arm by Occasional machinist
Lathe Carriage Stop by The Hobby Machinist NZ
Tool and Cutter Grinder by PaulsGarageProjects
Z-Axis Power Lift by AB-SHOP
Block Plane by Dr.Al

Mook - you'll be receiving a $100 prize, in your choice of Amazon, PayPal, or bitcoin. Please PM me your current email address and prize choice and I'll get it sent over right away.

This is your 4th Homemade Tool of the Week. Here are both of your Homemade Tool of the Week winning tools. Congrats again